New Bolt Ev Ev Premier ENCAR38941914

If the high voltage battery is charged close to complete or complete charging, smoke or heat can be generated from the high voltage battery, which is due to the possibility that the high voltage battery and other parts can be melted or damaged and exposed to the risk of fire. Recall

<*Production date by target>
Bolt EV: 2019.02.15 ~ 2019.05.09
Bolt EV: 2019.05.13 ~ 2020.08 .27
Bolt EV: 2021.02.08 ~ 2021.04.07
Bolt EV: 2019.01.07 ~ 2021.07.13
Bolt EUV: 2021.01.25 ~ 2021.05.06 >

<*If the software development and exchange parts are prepared in the future, it will be notified. (255, 0, 0); "> I would like to comply with important instructions >

">" [Insurance] It was confirmed that two extremely low manufacturing defects were present at the same time, and this manufacturing defect state was exacerbated by repeatedly/ habitually completely complete or almost complete filling after the battery was discharged significantly, and the battery manufacturing defect deteriorated and potential fire of potential fire There is a possibility of being exposed to danger.
1. Please change the maximum charging capacity of the vehicle to 90% until the new recall measure comes out, and change the 'Target Charge Level Option' by setting the charging option in the vehicle. If you do not change your configuration yourself, you can get a change of settings by visiting the Chevrolet Bolt EV work available service center that can be recalled,
2. After you operate the vehicle, please charge the battery as much as possible, and avoid the battery remaining distance falling below 70 miles (about 113 km).
3. In order to prevent the situation, please park the vehicle outdoors immediately after charging.

Change the maximum charging capacity of the vehicle to 90%

>

Even in the high voltage battery produced through the improved process than the existing high voltage battery, two manufacturing defects with extremely low occurrence may be present at the same time. The high voltage battery with this may generate smoke or heat, which causes the recall due to the possibility of a fire or damaged by high voltage battery and other parts. > <*Production date by target vehicle>

Bolt EUV electric vehicle (BOLT EUV): 2021.01.25 ~ 2021.05.06
Bolt EV (BOLT EV): 2019.05.13 ~ 2021.07.13

<*Before the visit, I would like to know and comply with the following "important instructions" . Through this recall, you can resolve customer inconvenience for and 3 items of "important instructions" P>

Improved diagnostic software installation and maximum charging amount 80% limit

>

<*For safety, Software Please take parent date measures . >

The high temperature gas that occurs during the operation of the front seat seat belt fretterer may cause an insulation under the lower part of the B-filler (the pillar between the front and the rear seat), which may be ignited. When it is operated, the recall according to the possibility of a fire in the lower part of the B-filler (if a smoke or a fire occurs at the bottom of the*B-filler, please get off the vehicle urgently for the safety of the passenger. 119 fire departments may be needed to prevent the spread of fire)

Insulation aluminum foil tape attached to insulation under the carpet

It was confirmed that two manufacturing defects with extremely low possibility of occurrence in the same battery salon of the high voltage battery were present, and when the high voltage battery was charged close to complete or complete charging I can generate columns, which can cause high voltage batteries and other parts to melt or damage, and there is a possibility of fire. Date>

Bolt EV: 2019.06.03 ~ 2021.07.26

Bolt EUV: 2021.03.19 ~ 2021.07.28

1. High voltage battery exchange

2. Improved diagnostic software update (maximum charging amount 100%)